If you are like me you spend a lot of time wandering flea markets, thrift stores, garage sales and auctions. When it comes to buying vintage jewelry keep in mind these tips before you buy. Nothing is more disheartening then getting a piece home and really looking at it after the “honeymoon” of finding it is over.  In the case of this signed Coro brooch , it wasn’t until I got home from a wonderful afternoon of junking that I realized the top left pearl was a lower quality replacement. Now it sits on my replacement shelf waiting for me to find a better match. Taking this into consideration I would not have paid what I did for it at all.
What is the physical condition of the piece? A well cared for and therefore more valuable piece does not have to look new, after all, it is termed vintage for a reason but it should not look it’s age either.

Missing, cloudy, black or mis colored rhinestones stones: these devalue the piece. If stones are missing inspect the area to see if they are missing due to becoming loose from the glue or in the case of prong set stones the prongs have broken off. In the case of missing stones due to old glue this is an easy repair, however, if the stones are missing because the prongs are broken or missing I would put it back on the shelf and say a little prayer to the Rhinestone Goddess for the mistreatment of one of her treasures.

Missing or broken parts and tacky plating:

 Here is a prime example of what to pass up. This brooch has some wonderful stones in it and they would be easily replaced. Take a good look at the metal. it is in very poor condition. The plating has worn off in places and someone down the line tried to brighten it up by using something on it to cover the old plating. Poor workmanship or repair flaws are a sure sign of a lower quality piece. Missing pieces such as the clasp mechanism on the back of a brooch takes some skill to repair. I have accumulated quite a few pieces of old brooches to use for repair. You will want to match the metal color and patina as closely as possible so your repair doesn’t stick out like a sore thumb. The same goes for necklace and bracelet clasps. make sure whatever you use keeps the original integrity of the piece as much as possible.

Poor repair workmanship: Sometimes you find a piece that has already been repaired. Take a good look at it. Did they use the right glue when resetting a rhinestone? If there is a hard yellow glue residue around the stone or pearl it was not repaired properly. Was the repair stone replaced with an inferior one?  These repair mistakes can be easily corrected by you and you can restore the piece back to it’s glory with the proper tools. (see previuos posts about repair kits and tools)